How to activate Windows 10 build 10240

Many users who performed a clean install of Windows 10 build 10240 cannot activate it. That is because Microsoft has disabled the online activation until the end of July 2015. If you are interested in activating Windows 10 build 10240, here are a few simple steps for you to do that without using any cracks, hacks or third party software. Windows 10 20240 activated How to activate Windows 10 build 10240

  1. Open an elevated command prompt.
  2. Type the following command and hit the Enter key:
    slmgr /ipk W269N-WFGWX-YVC9B-4J6C9-T83GX

    Wait for the message box popup that the key is installed.

  3. Now type the following command and press Enter
    slmgr /skms kms.xspace.in

    Again, wait for the message box.

  4. Finally, enter the following command:
    slmgr /ato

    After you hit the Enter key, Windows 10 build 10240 will become activated. Windows 10 20240 activation

You are done.

From Post  http://winaero.com/blog/how-to-activate-windows-10-build-10240/

Active Directory Health Check

pdtechguru

Active Directory – Health Check

Note : The following commands and script are to be run from a domain controller with enterprise / domain admin privileges. You may run the individual commands one by one or run the script. The script will run all the commands listed and generate a report

1. Replsummary operation quickly and concisely summarizes the replication state and relative health of a forest.

repadmin /replsummary

2. Synchronizes a specified domain controller with all replication partners, and reports if the sync was successful or not

repadmin /syncall /e

repadmin /syncall /Aped

A ( All partitions ) P ( Push ) E( Enterprise ) D ( Distinguished Name )

3. Forces the KCC on targeted domain controller(s) to immediately recalculate its inbound replication topology

repadmin /kcc *

4. Find the last time your DCs were backed up, by reading the DSASignature attribute from all servers

Repadmin /showbackup *

View original post 426 more words